User Manual
Menu Operations
26
LB / 4:3 PS / 16:9/Full Screen. You can press [OK]
key and [up/down] key to select each mode
circularly. 16:9 will provide user pillar box mode it
means user use 16:9 TV to display but need to see
a 4:3 full display picture. System will force press
wide screen picture to be narrow and there’re black
band on left and right site. Full Screen means
system won’t do any aspect ration translation, 16:9
picture source will be good display on a 16:9 TV
but will be too narrow on a 4:3 TV, and 4:3 picture
source will be too wide in a 16:9 TV but will be
good display in a 4:3 TV.
3.
Video Output: press [OK] key and [up/down] key to
select RGB or CVBS
4.
Volume Set: Press [OK] key and [up/down] key to
select Global or Each, Global means when you
adjust the volume on one channel, then all
channels volume will be adjusted. “Each” means
when you adjust the volume, then only current
channel volume will be changed.
5.
HDMI Audio: press [OK] key and [up/down] key to
select Mute, PCM or RAW, this menu controls the
HDMI port for digital audio output function, if you
select Mute option, then all channels no sound
from HDMI output when you adjust the volume,
even no press [MUTE] key. It is the same function
like press [MUTE] key in full screen. If you select
PCM option, the digital audio output will all
transformed to PCM format. If you select RAW,
then all audio output will maintain the original state.
6.
SPDIF is for switching the SPDIF audio output,
now we provide below options: Mute, PCM, Bit
stream. The same parameter settings like HDMI
Audio.
7.
RF System is use for switching RF format. Now we
provide below options: PAL-BG / PAL-I / PAL-DK /
NTSC.
8.
RF Channel is use for setting TV frequency range,
please refer to the table as below:
System
Range
PAL-BG
21~69(Italian; default value)
28~68(Australian)
PAL-I
21~69
PAL-D/K
21~69
NTSC
14~83
9.
RF function can receive satellite TV channel from
receiver and add new channel to your TV channel.
After setting, while you want to see the satellite
channels, you can search the channel in TV mode
and needn’t switch video to AV mode.
10.
OSD Transparency: This menu is for setting the
OSD transparency. You can press [left/right] key to
select the values. There are 7 levels of
transparency, 10%, 20%, 30%, 40%, 50% and
60% and “0%” (means no transparency function).
11.
Contrast / Brightness / Saturation /HUE : You can
adjust the parameter about the Video image by
using the [OK]button or press [left/right] key, the
default value is 50%.
12.
Press [menu] key to draw back from “AV Control”
menu.
11.3 Ethernet Setting
When you enter to “Ethernet Setting” menu, you will see
the screen like below:
11.3.1 Wire Network
.
1)
Select
Wire Network
on
Default Network Type
item.
2)
You can configure the Ethernet setting options.
DHCP
: The system will automatically assign a
dynamic IP address to the digital receiver
Static IP
: The IP Address, Subnet Mask, Gateway
and DNS options become enabled. You have to
set these options according to your IP address.
Bootp:
The system will automatically assign a
dynamic IP address to the digital receiver ,but in
diskless workstation LAN to effective
PPPOE:
In this menu you can get the IP
parameters via dial-up access, but need the