G. Trouble Shooting:
1. LED doesn't light when power switch is pressed to turn on mic.
a. Make sure
that the
batteries are not discharged.
b. Make sure
that the
batteries are installed correctly.
2. LCD shows when power switch is pressed to turn mic off.
a.
3. LCD panel shows unusual indications.
a. Remove the batteries from the microphone and re-install them.
4. No audio from microphone.
a. Check
that
the frequency of the transmitter is the same as that of the receiver.
b Make sure
that the
Mic switch is not set to Mute.
c Check if the distance between the transmitter and the receiver is too great.
d Check if the transmitter or the receiver is too close to any large metal objects.
5. Interference and signal Disturbance
.
a. Make sure there are no other wireless systems operating on the same
frequency in the same area. This includes Microphones, televisions, radio
stations, etc. Try setting the transmitter and receiver to a new channel.
H. Q&A
1.
Q:
How long can the microphone be operated with fully charged batteries?
A:
Re-chargeable batteries will last approximately 8 to 10 hours. Disposable
batteries will last approximately 13 hours.
Q:
How much time is required to recharge batteries from a fully exhausted
state?
A:
Approximately 4 to 5 hours.
Press the SET, UP and DOWN buttons at the same time in order to turn
the microphone off automatically.
The LCD display will flash about ten times
and then the microphone will turn off automatically. The microphone should
now turn on and off normally.
b. If the problem persists, call for service.
.
.
.
9
10
4. Press the Down button to display a lower numbered channel.
5. Press the SET button to activate the selected channel.
E. Battery Indications:
1. :Three bars means batteries are fully charged.
2. :One bar indicates low batteries.
R
eplace or recharge the
batteries.
3. :No bars showing indicates batteries are exhausted and after
flashing three times the power will automatically shut off.
F. Battery Charging Steps:
1. Rechargeable batteries need to be NiMH AA 1.2V with an amperage of
2100mAH or less as the charging function is limited to batteries of that
rating.
2. Recharging is best accomplished by using the AS-TV8DCC charger
3. Charging status:
a. Battery indicator flashing: Non-Rechargeable batteries installed or
no batteries installed.
Check the
batteries.
b. Battery indicator is flashing and LCD backlight is on: Failing,
corroded, or over-temperature batteries.
c. One or two bars showing: Batteries are charging successfully.
d. Three bars showing: Batteries have been fully charged.
* Please note the microphone will be turned off automatically while it is being
charged.
Содержание Any Spot QUAD
Страница 1: ......
Страница 2: ......
Страница 22: ...PLACE STAMP HERE GALAXY AUDIO P O BOX 16285 WICHITA KS 67216 0285...
Страница 24: ...V09222008...