Galanz WMUK004W, Руководство пользователя

Страница: 10 / 10

69kg/74kg Net weight / gross weight
Average Water consumption
54.5L
Average Energy consumption 1.05kWh
Remaining moisture content
Class B
Program time(min) 304
0.38W Power of left-on mode
0.38W Power of off-mode
0.02-0.8MPa Water pressure
2000W
Rated power
10.0kg
Washing / spin capacity
220V-240V~
,
50HZ
Power
WMUK004W
595X665X845mm
Technical Parameters
Model
Parameter
Outer dimension
(W x D x H)mm
Note:
Data can vary from the nominal values given depending on water pressure, water
hardness, water inlet temperature ,room temperature, type and volume of load,
fluctuations in the electricity supply and any extra options selected.
Appendix
Electric Diagram
Appendix
Troubleshooting guide
Possible Cause
The machine
fills overtime.
Door lock
alarm sounds
1. Water tap is not open.
2. Drain hose is too low.
3. Water inlet valve is damaged.
1. Open the water tap.
2. Hook up the hose.
3. Change the water inlet valve.
“E01”
Problem Error Code
The machine
drains overtime.
Water overflow.
Water sensor
works
abnormally.
The motor does
not work.
Heating tube
fault.
Temperature
sensor fault.
1. Ensure the door is fully closed.
2. Put the garment into the drum.
3. Change the door lock.
1.The door is not locked properly.
2. Garment is caught between the
door and seal.
3. Door lock is damaged
“E02”
“E04”.
“E03”
“E05”
“E06”
“E07”
Difficult explanation
1. Check the drain hose.
2. Clean the filter.
3. Check the drainage system and
clean it.
1. The drain hose is squashed or
kinked.
2. The drain pump filter is blocked.
3. The drainage system pipes are
blocked.
1. The water inlet valve is damaged.
2. The connection between the water
sensor and wire is not secure.
3. The water sensor is damaged.
1. The connection between the motor
and wire is not secure.
2. The motor has over-heated.
3. The motor is damaged.
1. Check the connection is secure.
2. Check if the machine is overloaded.
Switch off the machine, and retry
when the motor has cooled down.
3. Change the motor.
1. The connection between the
heating tube and wire is not secure.
2. The heating tube is damaged.
1. Check the connection is secure.
2. Change the heating tube.
1. The connection between the
temperature sensor and wire is not
secure.
2. The temperature sensor is
damaged.
1. Check the connection and ensure
it is secure.
2. Change the temperature sensor.
1. Change the water inlet.
2. Check the connection is secure.
3. Change the water sensor.
There is a
signal faut
“E09”
1.The signal transmission failed.
1.Restart the machine
Inverter fails
to start
“E10”
1. The connection between the
inverter and wire is not secure.
2. The inverter is damaged.
1. Check the connection and ensure
it is secure.
High AC
voltage
“H:AC”
1. The voltage of AC is too high.
1. It will be ok one the voltage return
to normal.
Low AC
voltage
“L:AC”
1. The voltage of AC is too low.
1. It will be ok one the voltage return
to normal.