11
ENGLISH
Using the appliance
1 Wash the fruit and/or vegetables and cut them into pieces that fit into the feed tube.
2 Press the on/off button to switch on the appliance.
This appliance only functions if all parts have been properly
3 Put the pre-cut pieces of ingredients into the feed tube and gently press them towards
the rotating sieve with the pusher .
Do not exert too much pressure on the pusher; this could affect the quality of the end result
and it could even cause the sieve to come to a halt.
Never insert your fingers or an object into the feed tube.
After you have processed all ingredients and the flow of juice into the juice cup or glass
has stopped, switch off the appliance and wait until the sieve has stopped rotating.
Do not let the appliance run for more than two minutes without interruption. If you have not
finished extracting juice, switch off the appliance and allow it to cool down for two minutes
before you continue.
Problem
The appliance does not
work.
The motor unit gives off
an unpleasant smell the
first few times the
appliance is used.
The appliance makes a
lot of noise, smells, is
too hot to touch,
smokes etc.
The sieve is blocked
The sieve touches the
feed tube or vibrates
strongly during proces-
sing.
Solution
The appliance is equipped with a safety system. It does not work if the parts have not
been mounted properly. Check whether the parts have been attached in the right
way, but switch off the appliance before you do so.
This is not unusual. If the appliance continues to give off this smell after a few times,
check the quantities you are processing and the processing time. After the appliance
has been running for 7 minutes, switch it off and let it cool down for 2 minutes.
Switch off the appliance and unplug it. Go to the nearest service centre or your dealer
for assistance.
Switch off the appliance, clean the feed tube and process a smaller quantity
Switch off the appliance and unplug it. Check if the sieve has been properly placed
into the pulp collector. The ribs in the bottom of the sieve should fit properly onto the
driving shaft. Check if the sieve is damaged. Cracks, crazes, a loose grating disc or
any other irregularity may cause malfunction.
