Single Site Programmer User Guide
1
GS-SNG-SITE-PRG-UG-001240
Page 14 of 30
Release 1.0
Preparing the Single Site Programmer Board
Hardware Setup for the GS1011MEx and GS1500M
ALERT!
Make sure you unplug/plug the 3.3V power cable with the ON/OFF switch in the OFF
position.
The following steps will guide you through setting up the Single Site Programmer hardware for the
GS1011MEx and GS1500M module (see
).
1.
Remove the contents of your Single Site Programmer Kit.
2.
Setting up the Single Site Programmer board:
a.
Plug DB9 cable into the DB9 serial connector on the Single-Site board. Plug the other end of
the DB9 cable into a DB9 serial port on your computer or laptop.
b.
Plug the 3.3V DC power cable into the 3.3V DC power connector on the Single Site
Programming board and plug the other end into a power outlet.
ALERT!
DO NOT turn ON the Single Site Programmer board until the module is installed into the
socket site.
