Talano & Alera Installation v2.6
9
Fitting Instructions
11) Offer up the side panel to the front of the bath. Guide it under the lip of the bath shell and then
mark the floor along the front of the panel to allow a wood batten (800mm x 25mm x 25mm) to be
fixed to the floor midway along the panel. This will prevent the panel moving at the base. Repeat as
required for other panels.
(End panel batten dimensions - 600mm x 25mm x 25mm)
Remove the panels and fix the wooded battens to floor
– Take care to allow for the thickness of the
panel. Fix the batten 4mm in from the marked line to allow for panel thickness. Once fitted the side
panel can be clipped into position. Further work may be required before the end panels can be
fitted (see step 12).
Figure 7.0
Affix wooden battens to the floor to prevent the panel moving at the base.
12)
End Panels
may require trimming depending on the panel configuration:
One Side panel and one End
– Trim end panel on the ‘wall side’
Two Side panels and one End panel - No trimming required
Two Side panels and two End panels - No trimming required
Where is trimming is required the trim should take place at the start of the ‘radius’ of the panel. We
recommend a wall batten is fitted in a similar manner to the floor battens.
13)
Offer up panels into place
and screw to battens and wall as needed.
14)
Attach labels as required
and fully test sequence prior to handover.
