Page
24 of 32
Model 13352, 13362, and 13372 Addressable Amplified Speaker Assemblies
Pub.: 43004-030A
d:\radio products-draft\gtc 43004\43004-030a\43004-030a.doc
06/05
Wiring
Each of the speaker assemblies is designed for bottom cable entry, where two ¾-inch conduit entries are
located. Field wiring can enter the speaker housing using the installed ¾-inch NPT cable bushing
(bottom right), or with rigid or flexible conduit by removing the installed bushing. The ¾-inch male
conduit plug (bottom left) can be removed for additional conduit connections. Refer to Figure 3. When
conduit entries are closed and sealed, the speaker is completely rain-tight.
Figure 3. Bottom view of speaker assembly
Install the necessary cable for wiring the speaker. Two pairs are required for wiring to the audio input
terminals for the Model 13352 unit only (one audio, one page closure). Two conductors are required for
supplying external 12 V dc power to all three models of the speaker. A minimum 22 AWG-conductor is
recommended for audio and page control and a minimum 20 AWG-conductor is recommended for 12 V
dc power.
The unit requires 12 V dc for operation, which can be supplied through the use of an external power
supply, Model 40404-048. The Model XB001 External Battery Kit or the internal Model BB133 Battery
Backup Kit are also available for provided a 12 V dc source. Refer to the installation instructions that
accompany these GAI-Tronics kits for more information.
N
OTE
:
For Model 13352 only
- The audio pair and page control conductors should be connected in
parallel between all controlled speakers as indicated in Figure 4 below.
Figure 4.
