44
Help Message Displayed
How to Reset the Message
ROTATE THE MILK CARAFE
DISPENSING SPOUT INTO
BREWING POSITION
A beverage with milk has been selected. The machine requires the carafe
handle spout to be placed into dispensing position .
Press the button "ESC" to cancel the selection.
ROTATE THE MILK CARAFE
DISPENSING SPOUT INTO
RINSING POSITION
The carafe rinse function has been selected .
Press the button "ESC" to cancel the selection.
PLACE MILK CARAFE
IN ITS HOUSING
The selected operation requires the milk container for brewing. Insert the
container in the machine as specifi ed in the manual.
Press the button "ESC" to cancel the selection.
15/01/10
10:38
Perform a descaling cycle on the machine .
When this message is displayed, it is still possible to use the machine, but
its correct operation might be compromised .
Damages caused by failure to descale the machine are not covered by
warranty.
15/01/10
10:38
The machine requests the "Intenza" water fi lter to be replaced with a
new one. Replace the fi lter as described on page 7.
The alarm is displayed only if the "Filter Enable" function is set to "ON".
(See page 30) .
Flashing red light . Machine in Stand-by .
The Stand-by settings can be changed .
Press the "
" button.
RESTART TO SOLVE
THE PROBLEM
E XX
An event has occurred which requires the machine restart. Take note of
the code (E xx) shown at the bottom.
Switch off the machine, wait 30 seconds and then switch it on again. If
the problem persists, contact the service centre .
maCHine WarninGS
