41
Optional program settings
en-us
Optional program settings
Optional program settings
At the factory, temperature and spin speed options, and
cycle duration ("Finish in" time) are pre-set for all cycles.
After selection of the cycle, these values are displayed in
the display field.
º
(EcoPerfect™)
Energy optimised washing by reducing the temperature
while achieving a washing result that is consistent with
the selected program, without the
º
(EcoPerfect™)
setting.
!
(Prewash)
For heavily soiled washing. Pour 1/3 of normal detergent
amount into pre-wash chamber I and remaining 2/3 into
main wash chamber II.
ô
(Rinse Plus)
This feature adds additional rinses to selected program
which is helpful for locations with soft water supplies or
to generally improve rinsing results. It will increase the
program duration.
ý
(Remote Start)
Briefly pressing the
ý
(Remote Start)
button activates or
deactivates the Remote start function. Activating the
Remote start function enables the appliance to be
started remotely via the Home Connect™ app.
NOTICE
Remote start can only be activated if the appliance door
is closed and the appliance is connected to your home
network.
NOTICE
Remote start will be deactivated in the following
circumstances:
– The door is opened.
– There is a power failure.
– The
ý
(Remote Start)
button was briefly pressed
again deactivating it.
– The center of the Program Selector was pressed
switching off the appliance.
– Once the program has ended.
– Any button was pressed or the program selector
was turned on the control panel.
Pressing and holding the
ý
(Remote Start)
button for at
least 3 seconds enters Home Connect settings.
6
(Finish in)
The program end (Finished in) time can be set in one
hour increments to a maximum of 24 h (hours). After
selecting the desired washing program (at the dial) but
before pressing the
A
(Start/Pause) button, press the
6
(Finish in) button until the desired time is displayed,
e.g. 8 h. Press the
A
(Start/Pause) button to start the
washer.
NOTICE
The cycle duration is included in the set Finish in time.
Here is an example of a 1hr:30min cycle time and an 8 h
Finish in time.
8 h is displayed (until the Energy-saving mode activates)
and counts down (approximately 6hr:30min) until the
washing cycle begins (at 1hr:30min) then the cycle
duration 1:30 is displayed and began. Total time
approximately 8 hours.
0
(Spin Speed)
Before and during the cycle, you can change the spin
speed range depending on the cycle progress.
Touch the appropriate button until the desired setting is
displayed.
No Spin
: This option eliminates the final spin and the load
remains saturated with the final rinse water. The pump is
activated to remove all residual water.
q
(Temperature)
Before and during the cycle, you can change the default
temperature range depending on the cycle progress.
Press the appropriate button until the desired setting is
displayed.
The maximum temperature range that can be set depends
on the cycle selected.
Содержание WM262700
Страница 1: ... DJJHQDX en us Use and Care Manual Installation Instructions Washer WM262700 ...
Страница 2: ...2 ...
Страница 55: ...55 STATEMENT OF LIMITED PRODUCT WARRANTY en us ...
