en
Cleaning and maintenance
40
6.
Put the service flap back on, lock it
into place and close it.
Note:
To prevent unused detergent
from flowing straight into the drain
during the next wash, pour 1 litre of
water into compartment
v
u
and start
the
Drain
programme.
The drain hose at the siphon
is blocked
1.
Switch off the appliance. Pull out the
mains plug.
2.
Loosen the hose clamp. Carefully
remove the drain hose; residual
water may leak out.
3.
Clean the drain hose and siphon
connecting piece.
4.
Re-attach the drain hose and secure
the connection point using the hose
clamp.
Filter in the water supply
blocked
First, reduce the water pressure in the
supply hose:
1.
Turn off the tap.
2.
Select any programme (except
Rinse/Spin/Empty).
3.
Press the
A
button. Allow the
programme to run for approximately
40 seconds.
4.
Press the
#
button. The appliance is
switched off.
5.
Pull out the mains plug.
Then clean the filter:
1.
Disconnect the hose from the tap.
Clean the filter with a small brush.
2.
For standard and Aqua-Secure
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance.
Use pliers to remove the filter and
then clean it.
3.
Connect the hose and check for
leaks.
