Gaggenau VR 414 610, Руководство по установке

Страница: 12 / 40

12
3 Connect the appliance to the mains and check
that it is working. If both illuminated rings behind
the control knobs flash alternately, the connecting
cable between the control console and the
appliance is not plugged in. Check that the
connecting cable is fitted correctly.
4 Flush installation only : it is imperative to test
functioning before jointing!
Joint the surrounding
gap with a suitable, temperature-resistant silicone
adhesive (such as OTTOSEAL
® S 70). Smoothen
the seal joint with smoothing agent recommended
by the manufacturer. Observe the notes on
processing the silicone adhesive. Do not operate
the appliance until the silicone adhesive has dried
completely (at least 24 hours, depending on room
temperature).
NOTICE: Unsuitable silicone adhesive used on
natural stone worktops will cause permanent
discoloration.
5 Remove lava stones from the plastic film and
place them in the lava stone trough.
6 Insert the grease tray and the lava stone trough in
the appliance.
7 Fold grill heating elements down.
8 Fit cast iron wire racks.
Connect Electrical Supply
Refer to data plate for more information. See "Service"
for data plate location.
The branch-circuit breakers ampacity, the wire sizes
and the connections must be conform to the
requirements of the National Electrical Code or
Canadian Electrical Code and all local codes and
ordinances.
Attach flexible conduit to the junction box. Connect
the lead wires to the junction box supply wires in
proper phase:
▯
black (L1) to black
▯
red (L2) to red
▯
green to ground
The mains connecting cable must at least correspond
to the type SJTO 3x16 AWG 105°C. The mains
connecting cable must only be purchased through and
connected by an authorised specialist.