Gaggenau VL414115, Руководство пользователя и инструкции по установке

Страница: 26 / 32

en
Installation instructions
26
3.
Drill four holes with a diameter of 6 mm.
4. Ensure that the angle of the cut surface to the work-
top is 90°.
5. Ensure that the stability of the fitted unit is guaran-
teed after the cut-outs have been made.
6. Take the necessary clearances to the worktop into
consideration.
7. After making the cut-outs, remove any shavings.
8.
Seal the cut surfaces so that they are heat-resistant
and waterproof.
9.
Maintain the minimum clearance of 10 mm between
the bottom of the appliance and unit parts.
Making the cut-out for the control knob
1.
Drill the hole for the control knob according to the
enclosed instructions.
2.
If the panel is more than 23 mm thick, cut out the
rear of the front panel for the retaining plate.
3.
Note the position of the control knob.
4.
After making the cut-outs, remove any shavings.
5.
Seal the cut surfaces so that they are heat-resistant
and waterproof.
Installing the control knob
1.
Hold the retaining plate in place against the rear of
the control panel.
2.
Use 2 screws to secure the retaining plate against
rotation.
‒
In the case of stone worktops, adhere the retain-
ing plate using heat-resistant, two-component ad-
hesive.
3. Remove the protective film from the rear of the illu-
minated ring.
4. Push the control knob into the hole.
‒
Always position the side marking on the control
knob on the left.
5.
Ensure that the retaining lug on the retaining plate is
located on the upper side and the control knob is in
the zero setting.