5
Control knob
Special accessories
You can order the following special accessories from
your specialist dealer:
▯
SH 260 001
Hinge holder for fitting the appliance cover
▯
VD 201 034
aluminium appliance cover
(for VG 264: two appliance covers necessary)
▯
VV 200 034
aluminium connection strip for combination with
further Vario appliances
Only use the accessories as specified. The
manufacturer accepts no liability if these accessories
are used incorrectly.
Burner assembly
Always assemble the burner parts correctly and evenly
to avoid faults during ignition or during use. The
catching pins on the burner ring must fit in the
corresponding holes on the burner head.
Burner assembly normal / high output burner
Operation
The markings on the control knob show the setting
between high and low heat. The flame setting is
infinitely variable between high and low heat.
Notes
‒
Only light a burner if all pan supports and burner
parts are properly assembled.
‒
Make sure the burners and ignition sparkers are
clean and dry.
‒
Fully press down the control knob and keep it
pressed, then turn it to the required position.
‒
After igniting, keep the control knob pressed for
around 2 to 4 seconds more. The thermal sensor
which controls the gas flow must be heated
before the knob can be released.
‒
If the flame should not ignite within 2 to 4
seconds, turn the control knob further to the left
to the low heat position and then back to the high
heat position after ignition. It is often faster to
ignite the burner in the low heat position because
the various gases have a differing ignition
response.
‒
If ignition fails depress knob and try again. If
flame is not established in 15 seconds release
the control knob and open a door and wait
1 minute before attempting a new ignition
procedure.
‒
Only use the recommended accessories. Do not
cover the stainless steel cooktop base (e.g. with
aluminium foil).
Abnormal operation
Flames are usually blue and sharply defined. If the
flames are yellowish or noisy or if the gas does not
ignite within the period specified under "switching on"
abnormal operation is indicated. Refer to chapter
"After-sales service" of this manual for service contact
details.
Switching on automatically
Your cooktop features ignition sparkers for automatic
ignition.
1
Place a suitable pot or pan on the corresponding
cooking position.
2
Fully press down the corresponding control knob
and turn it anticlockwise to the required position.
The burner lights automatically.
3
Keep the control knob pressed for a few seconds
after ignition.
The flame size can be set continuously between high
and low by slowly turning the control knob.
The markings show the
position of the corresponding
burner and the setting
between high and low heat.
The flame setting is infinitely
variable between high and
low.
EXUQHUOLG
EXUQHUKHDG
VSDUNHU
KHDWVHQVRUIRU
IODPHPRQLWRULQJ
