3
Safety Codes and Standards
This appliance complies with the latest version of one or
more of the following standards:
z
z
CAN/CSA C22.2 No. 61 - Household Cooking Ranges
z
z
UL 858 - Household Electric Ranges
z
z
CAN/CSA C22.2 No. 150 Microwave Ovens
z
z
UL 923 - Microwave Cooking Appliances
z
z
UL 507 - Electric Fans
z
z
CAN/CSA C22.2 No. 113 - Fans and Ventilators
z
z
CSA C22.2 No. 64 - Household Cooking and Liquid-
Heating Appliances
z
z
UL 1026 - Electric Household Cooking and Food Serv-
ing Appliances
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.
Grounding Instructions
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk
of electric shock by providing an escape wire for the
electric current. This appliance is equipped with a cord
having a grounding wire with grounding plug. The plug
must be plugged into a outlet that is properly installed
and grounded.
WARNING
Improper use of the grounding can result in a risk
of electric shock.
Consult a qualified electrician or serviceman if the
grounding instructions are not completely understood,
or if doubt exists as to whether the appliance is properly
grounded.
Do not use an extension cord. If the power supply cord
is too short, have a qualified electrician or serviceman
install an outlet near the appliance.
The installer must perform a ground continuity check on
the power outlet box before beginning the installation
to insure that the outlet box is properly grounded. If not
properly grounded, or if the outlet box does not meet
Electrical Requirements, a qualified electrician should
be employed to correct any deficiences.
Clearances and Dimensions
z
z
For safety considerations, do not install Microwave
Built-in Drawer in any combustible cabinetry which
is not in accord with the stated clearances and
dimensions in the "Microwave Built-in Drawer
Measurements” section following. See Figure 3
(standard installation) or Figure 4 (flush installation).
z
z
Dimensions that are shown in Figure 3 (standard
installation) or Figure 4 (flush installation) must be
used. Given dimensions provide minimum clearance.
Locate electrical outlet in the shaded area in the upper
left-hand corner of the cutout. See Figure 6.
z
z
Supporting surface must be solid and level. Pay
special attention to the floor of the cabinet opening
on which the Microwave Built-in Drawer will sit. The
floor of the opening should be constructed of plywood
strong enough to support the weight of the oven
(about 100 pounds).
z
z
Check the location where the Microwave Built-in
Drawer will be installed for proper electrical supply.
z
z
Your oven can be built into a cabinet or wall as a
stand-alone unit or under a built-in gas or electric wall
oven and the followings:
GAS
COOKTOPS
ELECTRIC
COOKTOPS
INDUCTION
COOKTOPS
VG231214CA
VG232214CA
VG264214CA
VG295114CA
VG295214CA
VG414210CA
VG424210CA
VG491210CA
CE490612
VE230614
VE260614
VF230614
VF414610
VK230714
VK414610
VP230614
VP414610
VR230614
VR414610
CI481612
CI491602
CI491612
CX491610
VI414610
VI424610
VI491610
z
z
Check to be sure that there is a clearance of 2 inches
or greater between the top of the Microwave Built-in
Drawer unit and the bottom of a built-in wall oven
above it.
z
z
The microwave interior will easily accommodate a
9" x 13" oblong dish or a bag of microwave popcorn.
Содержание MW 420 620
Страница 19: ......
