Gaggenau DI250440, Руководство по эксплуатации

Страница: 31 / 34

31
Installation and connection
Warm water connection *
Warm water connection
* depending on model
The dishwasher can be connected to cold or hot water
up to max. 60 °C.
Connection to hot water is recommended if the hot
water can be supplied by energetically favourable
means and from a suitable installation, e.g. solar
heating system with circulation line.
This will save energy and time.
The hot water setting
‘
:
‹‚
allows you to adjust your
appliance optimally to operation with hot water.
It is recommended to have a water temperature
(temperature of the incoming water) of at least 40 °C
and no more than 60 °C.
It is not recommended to connect the appliance to hot
water if the water is supplied from an electric boiler.
Setting hot water:
1 Close the door.
2 Switch on ON/OFF switch
(
.
3
Hold down programme button
#
and press
START button
P
until
•
:
‹
... is indicated on the
digital display.
4
Release both buttons.
The LED for button
#
flashes and the digital
display
)"
displays the factory setting
•
:
‹…
.
5
Press programme button
#
until the factory set
value
‘
:
‹‹
is indicated on the digital
display
)"
.
To change the setting:
1 By pressing the
3
button, you can switch the
hot water setting off
‘
:
‹‹
or on
‘
:
‹‚
.
2
Press START button
P
.
The set value is saved.
Electrical connection
▯
Connect the appliance only to 200 V
and 50 Hz or 60 Hz alternating current via
a correctly installed socket with protective
conductor. See rating plate for required fusing
9:
.
▯
The socket must be near the appliance and freely
accessible following installation.
If the plug is not freely accessible, an allpole
disconnector with a contact opening of at least 3
mm must be fitted on the installation side
to satisfy the relevant safety instructions.
▯
The connection may be modified by technicians
only.
▯
A power cord extension may be purchased from
customer service only.
▯
Use only a residual current operated circuit-
breaker which features the symbol
‚
. Only this
extension guarantees compliance with
the currently valid regulations.
▯
The appliance features a water damage
protection system. Please note the system will not
function
unless
the power supply is connected.
Removing the appliance
Also observe the sequence of worksteps here.
1
Disconnect the appliance from the power supply.
2 Turn off the water supply.
3 Undo the waste water and drinking water
connection.
4
Loosen fastening screws for the furniture parts.
5
If fitted, remove the base panel.
6 Pull out the appliance, carefully pulling the hose
behind.