Gaggenau DF480161CN, Инструкция по эксплуатации

Страница: 42 / 48

en
Installation and connection
42
Technical specifications
▯
Weight:
up to 60 kg
▯
Voltage:
220–240 V, 50 Hz or 60 Hz
▯
Connected load:
2.0 - 2.4 kW.
▯
Fuse:
10/16 A (UK 13 A).
▯
Power input:
off mode (Po)* 0,50 W.
left on mode (Pl)* 50 W.
*according to regulations (EU) nos. 1016/2010 and
1059/2010.
Additional functions and settings may increase the
power input.
▯
Water pressure:
at least 0.05 MPa (0.5 bar), maximum 1 MPa (10 bar).
At a higher water pressure:
connect pressure-reducing valve ahead.
▯
Inlet rate:
minimum 10 litres/minute
▯
Water temperature:
cold water.
Hot water:
Maximum temperature 60 °C.
▯
Capacity:
12–15 place settings (depending on the features of
your dishwasher).
Installation
The required installation dimensions can be
found in the installation instructions. Level
the appliance with the aid of the height-adjustable feet.
Ensure that the appliance is situated
securely on the floor.
▯
A built-under or integrated appliance which is
installed subsequently as a free-standing appliance
must be secured to prevent it from overturning, e.g.
by screwing it to the wall or by installing it under a
continuous worktop which is screwed to adjacent
cupboards.
▯
The appliance can easily be installed in a fitted
kitchen between wooden and plastic walls.
Drainage connection
1.
The required work sequence can be
found in the installation instructions. If required, fit
a siphon with an drainage connection.
2.
Connect the waste-water hose to the drainage
connection of the siphon with the enclosed parts.
Ensure that the drainage hose is not kinked, crushed
or twisted and that there is no cover
plate in the drainage to prevent the waste water from
flowing out!
Drinking water connection
1.
Fasten the drinking water connection to the tap
according to the installation instructions using
the enclosed parts.
Ensure that the drinking water connection is not
kinked, crushed or twisted.
2.
When replacing the appliance, always use a new
water supply hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum 1 MPa (10 bar).
At a higher water pressure:
connect pressure-reducing valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water.
Hot water:
Maximum temperature 60 °C.