Gaggenau DF250560, Руководство пользователя

Страница: 29 / 38

Fault, what to do?
aus
29
Utensils not dry. No or too little rinse aid in the
dispenser. Refill rinse aid.
Programme selected without drying. Select programme with drying.
Water collecting in depressions on
the utensils and cutlery. Arrange utensils in a sloping position,
arrange affected utensils as sloping as
possible.
The combined detergent used has a
poor drying performance Use different combination detergent with
better drying performance. Use of rinse aid
also increases the drying performance.
ExtraDry to increase drying not
activated. Activate ExtraDry.
Utensils were removed too early or
drying process had not ended yet. Wait until program ends or wait until 30 min
after program ends before removing
utensils.
The eco rinse aid used has a limited
drying performance. Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Plastic utensils not dry. Special properties of plastic. Plastic has a lower heat storage capacity
and therefore dries less well.
Cutlery not dry. Cutlery not arranged properly in the
cutlery basket. Separate cutlery if possible, prevent contact
points.
Cutlery not arranged properly in the
cutlery drawer. Arrange cutlery properly and separate if
possible.
Appliance interior wet after rinse
cycle. No appliance fault On account of the “Condensation drying”
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.
Food remnants on the utensils. Utensils placed too closely together,
utensils basket overfilled. Arrange utensils with adequate clearance
between them ensuring that the spray jets
can reach the surface of the utensils.
Prevent contact points.
Spray arm rotation obstructed. Arrange utensils so that the spray arm can
rotate without obstruction.
Spray arm nozzles are blocked. Clean the spray arm nozzles.
Filters
1R
dirty. Clean filters.
Filters
1R
inserted incorrectly and/
or not engaged.
Insert and engage filters correctly.
Rinse programme too weak. Select a more intensive rinse programme.
Increase sensitivity of the sensors.
~
"Sensor setting" on page 22
Utensils precleaned too intensely;
sensors therefore decide on weak
programme sequence. Stubborn
soiling cannot be completely
removed. Do not prerinse utensils. Remove only large
food remnants.
Increase sensitivity of the sensors.
~
"Sensor setting" on page 22
Recommended programme Intensive.
Tall narrow receptacles in corner
areas are not rinsed adequately. Do not place hollow receptacles too
obliquely and do not place in the corner
area.
Top basket
12
on right and left not
set to same height.
Set top basket to same height using side
levers.
Fault Cause Remedial action