Gaggenau DF250141, Руководство по эксплуатации

Страница: 19 / 34

19
Operating the appliance
Remaining running time display
When the programme is selected, the programme
running time is indicated on the digital display
h
.
When the programme has started, the remaining
running time is displayed on the floor (only for
settings
†
:
‹‚
and
†
:
‹ƒ
).
The running time is determined during the programme
by the water temperature, the number of utensils
as well as the degree of soiling and may vary
(depending on the selected programme).
Timer programming
Timer programming *
* depending on model
You can delay the start of the programme in 1-hour
steps up to 24 hours.
1
Open the door.
2 Switch on ON/OFF switch
(
.
3 Press button
P
+ until the digital display
h
jumps to
œ
:
‹‚
.
4
Press
P
+ or – button until the displayed time
corresponds with your requirements.
5
Press START button
`
, timer programming is
activated.
6
To delete timer programming, press the
P
+ or
– button until
h
œ
:
‹‹
is indicated on the digital
display.
You can change your programme selection at any
time until the programme starts.
7
Close the door.
End of programme
The end of the programme
O
/
‹
:
‹‹
is displayed on
the floor – provided the optical display is switched on
and is visible.
The end of the programme is also indicated by an
acoustic signal. This function can be changed as
follows:
1 Open the door.
2
Switch on ON/OFF switch
(
.
3
Hold down programme button
#
and press
START button
`
until
•
:
‹
.... is indicated on the
digital display.
4 Release both buttons.
The LED for button
#
flashes and the digital
display
h
displays the factory setting
•
:
‹…
.
5
Press programme button
#
until the factory set
value
›
:
‹ƒ
is indicated on the digital display
h
.
To change the setting,
1
Press programme button
3
. Each time the
button is pressed, the set value increases by one
level; when the value of
›
:
‹„
has been reached,
the display jumps back to
›
:
‹‹
(off).
2
Press START button
`
, the set value is saved.
3 Close the door.
Note
Depending on the setting for “Automatic switch off
when programme ends or interior light”, the optical
display is no longer or only briefly visible.