Gaggenau CV492100, Руководство пользователя

Страница: 11 / 36

Operating modes
en
11
Symbol Cooking zone type Switching on
Single cooking zone Use cookware of a suitable size.
Flexible cooking zone You can find more information in "Flexible cooking zone".
→
Page 15
⁠ FlexPlus cooking
zone The FlexPlus cooking zone always switches on in conjunction with
one of the flexible cooking zones. You can find more information in
"FlexPlus cooking zone".
→
Page 16
6.5 Residual heat indicator
The hob has a two-stage residual heat indicator for
each cooking zone. This indicates that a cooking zone
is still hot. Do not touch the cooking zone if the resid-
ual heat indicator is lit.
The following is displayed depending on the amount of
residual heat:
¡
display: High temperature
¡
display: Low temperature
The illuminated ring on the control knob flashes.
If the FlexPlus cooking zone has been activated, the
FlexPlus cooking zone display also lights up.
If you remove the cookware from the cooking zone dur-
ing cooking, the power level indicator flashes and the
illuminated ring on the control knob lights up orange.
If you switch off the cooking zone, the residual heat in-
dicator lights up and the illuminated ring on the control
knob flashes. Even if the hob has already been
switched off, the residual heat indicator remains lit for
as long as the cooking zone remains warm.
7 Operating modes
You can use your appliance in air extraction mode or
circulating-air mode.
7.1 Air extraction mode
The air which is drawn in is cleaned by the grease fil-
ters and conveyed to the exterior by a pipe system.
The air must not be discharged into a
flue that is used for exhausting fumes
from appliances burning gas or other
fuels (not applicable to appliances that
only discharge the air back into the
room).
¡
If the exhaust air is to be conveyed
into a non-functioning smoke or ex-
haust gas flue, you must obtain the
consent of the heating engineer re-
sponsible.
¡
If the exhaust air is conveyed
through the external wall, a tele-
scopic duct should be used.
7.2 Air recirculation mode
The air which is drawn in is cleaned by the grease fil-
ters and an odour filter, and conveyed back into the
room.
To bind odours in circulating-air mode,
you must install an odour filter. The dif-
ferent options for operating the appli-
ance in circulating-air mode can be
found in our catalogue. Alternatively,
ask your dealer. The required accessor-
ies are available from specialist retail-
ers, from customer service or from the
Online Shop.
8 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
8.1 Setting Home Connect
1. Carry out the following operating steps without inter-
ruption.
2. Push in the control knob and turn it anti-clockwise to
the position.
Leave the control knob pushed in.
3.
Turn the control knob clockwise to ⁠.
Leave the control knob pushed in.