10
Installation Procedure
Installation Procedure
1
Before inserting the appliance into the cut-out of
the countertop, remove the following transport
locks:
‒
2 plates on the front side of the appliance
‒
2 fastening screws on the underside of the
appliance
Plug holes on the underside of the device with
the locking cap.
Note:
Keep the transport locks. Re-mount transport
locks before transporting the appliance (e.g. during a
move).
2
Push appliance from above into the cut-out of the
countertop.
Note:
Make sure that the seal on the underside of
the cover does not slide.
3
Only for built-in installation: Before joining, make
sure to perform a function test!
Join surrounding
gap with a suitable, temperature-resistant silicone
glue (e.g. Novasil
®
, Pactan
®
). Smooth seal joint with
a smoother recommended by the manufacturer.
Heed the processing instructions for the silicone
glue. Only start up the appliance after complete
drying of the silicone glue (at least 24 hours,
depending on the room temperature).
NOTICE:
Unsuitable silicone glue causes
permanent discoloration with natural stone
countertops.
4
Insert appliance evenly into the cut-out. Press firmly
from above into the cut-out.
Notes
‒
The appliance must sit fast in the cut-out and
may not slide (e.g. during cleaning). For cut-out
width on the upper tolerance limit, if necessary
fasten ledges on the side in the cut-out.
‒
Remove both plastic parts on the left and right
of the cover.
5
Level the appliance in the cupboard. Ensure that
the cover for the appliance lays flat on the
countertop. Bend the lower end of the fastening
bracket by 90° at the perforation. Screw the
fastening bracket on the appliance and on the
