Installation instructions
en
41
5.
Thread the cables through the openings of the
frame cover.
6.
Undo the strain relief on the cable on the appliance
and pull out the cable.
7.
Remove the strain relief fitted at the factory.
Put the strain relief to one side.
8.
ATTENTION!
There is a risk of damage to the appli-
ance if the cable is coiled up.
▶
Always secure the cable firmly using the strain
relief so that it does not coil up fully in the appli-
ance.
Thread the cable on the appliance through the
opening in the frame cover and use the strain relief
supplied to secure it.
9.
Thread the four cables into the cable tensioner and
apply equal tension.
Do not shorten the cables.
10.
Readjust the cables. To do this, relieve the load on
the appliance, loosen the cable tensioner and push
the cables up.
11.
Thread the four enclosed cable clamps and secure
in place approx. 20 mm in front of the cable ten-
sioner.
20 mm
2
Tighten the screws by hand.
