15
12/21 REV 8/22
GB704SH
-
5 PNEUDRAULIC INSTALLATION TOOL.
.
REMOVING POPPET VALVE (A
-
648)
1.
Remove set screw (401771) and lever (704345) from handle assembly (700343).
2.
Remove pin (703543) from handle assembly (700343).
3.
Pull poppet valve (A
-
648) from handle (700343). If unable to remove by hand, carefully
remove using pliers, being careful not to compromise poppet valve (A
-
648).
INSTALLING POPPET VALVE (A
-
648)
1.
After replacing o
’
rings on poppet valve (A
-
648), insert poppet valve (A
-
648) into handle assembly
(700343) (Note direction in image above) and push with thumb until it stops.
2.
Reinsert pin (703543) into hole on handle assembly (700343).
3.
Re
-
attach the lever (704345) and tighten set screw (401771).
Note: View above shows proper orientation of lever.
POPPET VALVE
WARNING
:
Disconnect tool from its power source before poppet valve (A
-
648) removal or installation. Severe personal injury
may occur if power source is not disconnected.
CAUTION:
Use caution when removing the poppet valve (A
-
648) from the handle assembly (700343).
CAUTION:
Ensure all parts are assembled properly and correctly fastened to the tool before using.
OVERHAUL
HOLE FOR PIN
PROTRUDING FROM
HANDLE ASSEMBLY
ACTUATOR ASSEMBLY
HOLE
Top Hole locates on dowel
Bottom Hole locates on
poppet valve assembly
Poppet valve assembly sits
flush against pin diameter
in hole
