3
Rev. 1/14
WARNING
Do not pull fastener unless it is placed
in an
assembly, pin will eject forcibly
when pintail breaks
off. Severe
personal injury may result.
WARNING
Do not operate without Stat-O-Seal
(S572) and cap
screw (402482). Pressurized
hydraulic fluid may
cause severe
personal injury.
WARNING
When operating, repairing or overhauling tool, wear
approved eye protection. Do not look in front of
nose assembly or rear of tool when installing
fastener.
WARNING
Always disconnect tool from power
before
performing any maintenance
to any tool or nose
assembly.
Ensure
that all connections are proper
and
there are no visible leaks from tool
or hoses
before connecting to power.
WARNING
Do not operate if deflector, bottle,
catcher bag or
vacuum tube is
removed or damaged, broken
pintails may eject forcibly from rear of tool. Severe
personal injury
may result.
CAUTION
Ensure that nose assembly and tip
are properly
matched for the
fastener being installed.
CAUTION
Keep Nose Assemblies clean and free
of chips and
debris.
WARNING
Be sure there is adequate clearance for
tool and
operator's hands before
proceeding. Keep fingers
clear of any moving parts. Keep fingers clear from
fasteners and installed materials.
Severe personal
injury may result.
WARNING
It is required to use hearing protection. A test was
carried out in a simulated work environment where
the background level was 73.2 DBA. In this
condition the max level was 81.5 DBA. Therefore, it
is required where prolonged use, hearing
protection be used.
CAUTION
Do not use beyond the design intent.
WARNING
Tool must be maintained in a safe working
condition at all times and examined on a regular
daily basis for damage or wear. Any repair should
be done by qualified personnel trained on Gage Bilt
procedures.
SAFETY WARNINGS
WARNING
Where prolonged use is foreseen, it is
recommended a tool balancer be used. Check
suspension device to ensure that it is secure.
WARNING
Do no use tool in explosive atmosphere.
CAUTION
Tool is not to be used as a hammer.
WARNING
Risk of crushing exists if nose assembly is not
attached.
NOTE:
PLEASE READ THIS MANUAL BEFORE SERVICING OR USING THIS TOOL.
REVIEW ALL WARNINGS AND CAUTIONS TO PREVENT
SEVERE PERSONAL INJURY OR DAMAGE THE TOOL.
WARNING
It is recommended tool be operated 50 out of every
60 minutes, where prolonged use is expected.
WARNING
Shock:
It is recommended operator wear a suitable glove
during operation where prolonged use is expected.
WARNING
Air pressure not to exceed 100 psi. (6.9 bar), except where
noted
