9
Rev. 9/11
HEAD
Remove nose assembly from tool before attempting disassembly of head assembly.
Remove end cap (730717). Push against threaded end of head piston (730311) to slide it out of head cylinder (730398). Be careful
not to damage threads or cause burrs on polished piston rod surface.
WARNING:
DISPOSE OF HYDRAULIC FLUID IN ACCORDANCE WITH ALL ENVIRONMENTAL LAWS AND REGULATIONS
APPLICABLE TO YOUR AREA.
The re-assembly sequence is the opposite of disassembly. (See Filling and Bleeding instructions.) Apply Loctite® #242 and torque
the four button-head cap screws (A-928) uniformly to 40 inch lbs. to prevent leakage around the gasket.
CLEANING AND LUBRICATING PROCEDURE
Daily cleaning and lubrication of nose assembly will greatly reduce
downtime and increase life of components. Using sewing machine
oil, or an equivalent cleaner/lubricant, follow instructions below.
1. Disconnect tool vacuum line (if equipped).
2. Point nose assembly into oil as shown (Fig. A).
3. Cycle tool 8-10 times and wipe dry.
Fig A.
211102 - NUT
730201 - NOSE FITTING
405889 - O'RING
401113 - BACK-UP RING
401113 - BACK-UP RING
S945 - O'RING
403841 - O'RING
752122 - DEFLECTOR
240102
RETAINING NUT STOP
200506-2 - PINTAIL TUBE
(FOR USE WITH BLIND RIVETS SMALLER THAN 3/16" Ø)
401105 - BACK-UP RING
730398 - HEAD CYLINDER
A-1044 - O'RING
730311 - PISTON
401102 - BACK-UP RING
730717 - CAP
402482 - BUT. HD. CAP SCREW (2)
S572 - STAT-O-SEAL (2)
403812 - O'RING