15
12/21 REV 4/22
GB704SH
-
5 PNEUDRAULIC INSTALLATION TOOL.
.
REMOVING POPPET VALVE (A
-
648)
1.
Remove set screw (401771) and lever (704345) from handle assembly (700343).
2.
Remove pin (703543) from handle assembly (700343).
3.
Pull poppet valve (A
-
648) from handle (700343). If unable to remove by hand, carefully remove using
pliers, being careful not to compromise poppet valve (A
-
648).
INSTALLING POPPET VALVE (A
-
648)
1.
After replacing o
’
rings on poppet valve (A
-
648), insert poppet valve (A
-
648) into handle assembly (700343)
(Note direction in image above) and push with thumb until it stops.
2.
Reinsert pin (703543) into hole on handle assembly (700343).
3.
Re
-
attach the lever (704345) and tighten set screw (401771).
Note: View above shows proper orientation of lever.
POPPET VALVE
WARNING
:
Disconnect tool from its power source before poppet valve (A
-
648) removal or installation. Severe personal injury
may occur if power source is not disconnected.
CAUTION:
Use caution when removing the poppet valve (A
-
648) from the handle assembly (700343).
CAUTION:
Ensure all parts are assembled properly and correctly fastened to the tool before using.
OVERHAUL
HOLE FOR PIN
PROTRUDING FROM
HANDLE ASSEMBLY
ACTUATOR ASSEMBLY
HOLE
