Gage Bilt GB703SH, Оригинальное руководство пользователя

Страница: 15 / 24

15
12/09 REV. 4/23
GB703SH S/N: 1403 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
OVERHAUL
POPPET VALVE ASSEMBLY (703651)
WARNING :
Disconnect tool from its power source before poppet valve assembly (703651) removal or installation. Severe
personal injury may occur if power source is not disconnected.
CAUTION:
Use caution when removing the poppet valve assembly (703651) from the handle assembly (700343).
CAUTION:
Ensure all parts are assembled properly and correctly fastened to the tool before using.
Images may not reflect actual tool.
Top Hole locates on dowel
Bottom Hole locates on
poppet valve assembly
Poppet valve assembly sits
flush against pin diameter
in hole
HOLE FOR POPPET
VALVE ASSEMBLY
HOLE FOR PIN
PROTRUDING FROM
HANDLE ASSEMBLY
REMOVING POPPET VALVE ASSEMBLY (703651)
1. Loosen and remove set screw and lever from handle assembly (700343).
2. Remove pin from handle assembly (700343).
3. Pull poppet valve assembly (703651) from handle assembly (700343). If unable to remove
by hand, pull out using pliers being careful not to compromise the poppet valve assembly
(703651).
INSTALLING POPPET VALVE ASSEMBLY (703651)
1. After replacing o ’ rings on poppet valve assembly (703651), insert poppet valve assembly
(703651) into handle assembly (700343) (Note direction in picture provided) and push with
thumb until it stops.
2. Reinsert pin into hole on handle assembly (700343).
3. Re - attach the lever and tighten set screw.
Note: View above shows proper orientation of lever.