GADLEE GTS 1250, Руководство оператора

Страница: 31 / 40

ENGLISH
11
•
Prepare the machine as described above.
Starting up/use:
i INFORMATION
The seat (fig. A, ref. 4) has two safety sensors which allow the machine to move
only when the operator is seated.
•
Turn the key switch (fig. C, ref. 1) into the "ON" position without pressing the drive
pedal (fig. A, ref. 3), check the battery charge as shown by the Display LCD (fig. C, ref.
2). If the battery level is low, turn the key switch back to the "OFF" position and
recharge the batteries (see chapter 8).
•
Use the direction selector (fig. C, ref. 5) to set the direction of movement;
•
Take the machine to the work area by starting it up with your hands on the steering
wheel and pressing the pedal (fig. A, ref. 3) on the front to move. The speed can be
adjusted from zero to maximum by adjusting the pressure exerted on the pedal and
speed potentiometer (fig. B, ref. 6).
•
Make sure the debris bin is perfectly closed.

IMPORTANT
Opening of the debris bin disables operation of the suction fan and centre brush.
•
Push the main brush lever to “START” position(fig. D, ref. 1) to lower the main brush
on the floor and adjust the pressure of the centre brush according to the type of floor
and dirt to be picked up. The brush is self-levelling
•
Press the suction switch (fig. D, ref. 2) to “Suction On” position
•
Turn the side brush lever to “ON” position (fig. P)
•
Use the knob to adjust the speed of the side brush (fig. C, ref. 7)
•
Start cleaning, select forward or backward by direction selector (fig. C, ref. 5),
manoeuvring with your hands on the steering wheel and the moving the machine for by
pressing the pedal (fig. A, ref. 3).
•
The working speed can be set using the maximum speed regulator (fig. C, ref. 6).

IMPORTANT
To avoid damaging the surface of the floor to be treated, avoid rotating the
brushes/pads with the machine stationary.

IMPORTANT
Each 30 minutes of work, activate the filter shaker button (fig. C, ref. 5) for 30
seconds to clean the suction filter. During this operation, the suction fan shuts off
automatically.

IMPORTANT
Avoid passing over puddles of water. If the work surface is wet, you can only
continue using the machine if you turn off the suction fan as damp/wet dirt reduces
the performance of the suction filter.
i INFORMATION
For good results, empty the debris bin often and keep the filter clean by shaking it
using the special device.
Emptying the debris bin:

IMPORTANT