Installing the daughter card
1. Turn off your computer and open the case.
2. Remove the Wave/4 card from your computer.
3. Locate the 26-pin interface connector JP2 on the Wave/4 card.
4. Orient the daughter card with respect to the Wave/4 card as shown in the diagram.
Center the card connector on the pins. Carefully push the daughter card until it is
firmly seated. All 26 pins should be seated in the daughter card connector.
n
Choose: ‘Driver from disk provided by hardware manufacture’
n
Make sure that ‘Copy Manufacturer’s files from:’ shows, ‘A:\’
n
Insert the Wave/4 Drivers Disk, and click OK
n
The driver files will be copied and the system automatically
setup to use the Wave/4 card
Connecting a wavetable synthesizer daughter card to the Wave/4
The Wave/4 card includes a special, 26 pin connector (13 x 2) for adding a
wavetable synthesizer “daughter” card. These cards are available from
several manufacturers. Due to mechanical constraints, the Wave/4 card will
accommodate a reduced-size, mini wavetable card, but a full-sized card will
NOT fit. For example, the
Yamaha DB50XG wavetable card will NOT fit
on
the Wave/4 card, but the Kurzweil synth wavetable card from Gadget Labs
will fit fine. Contact us if you have any questions or need assistance in
locating an appropriate wavetable card.
MIDI adapter with DIN connectors. The DIN
connectors are labeled In, Out and Thru
audio OUT from Wavetable synth card (stereo)
Channel 2 (Ch2), audio OUT (stereo)
Channel 1 (Ch1), audio OUT (stereo)
Channel 2 (Ch2), audio IN (stereo)
Channel 1 (Ch1), audio IN (stereo)
Connecting audio & MIDI
to the external connector
Here’s the connector layout
from top to bottom
è
For audio, all connectors
are standard line level,
stereo left + right.
NOTE:
Microphones do not
have enough signal strength and
must be amplified by a mixer or
preamplifier prior to connecting
to the Wave/4 card.
3
Daughter card
connector
After installation
IMPORTANT !
Make sure that all pins are
seated in the daughter card
connector. If any pins are
showing on either side of the
connector, it is seated incor-
rectly. If this occurs, gently
remove the daughter card by
pulling it straight up from the
Wave/4 card and repeat Step 4
below. Failure to correctly
install the daughter card WILL
result in damage to the daugh-
ter card when you turn on your
computer.
Wave/4 card
Before installation
