3.- USING THE THERMAL RADIATOR
ELECTRONICS MODELS RFP
Operation in electronic models is controlled by means of two rotary
knobs.
It is possible to regulate the temperature level with accuracy by means
of the
temperature selector
. The heating indicator will be lit when the
heater is consuming energy. When this dial is set in * position the heater
is in frost protection mode, at this stage if the room temperature drops
below 3ºC the heater will connect itself automatically.
There are three selectable positions with the
mode selector
dial:
0
: The heater is switched off permanently. No frost protection mode
here.
: SUN mode on, the heater maintains the set temperature with the
temperature selector dial.
: Moon mode on, the heater maintains a temperature 3ºC lower
than the one set with the temperature selector dial.
- The studs and screws are in the accessories bag.
- Hung the unit on the hooks of the brackets.
- By turning the screw the metallic square will go downwards, retaining the heater. Repeat this on the other bracket.
Use the heater as a
template and mark the
fixing points on the wall
using a pencil through the
two fixing holes in the
square brackets.
Position and fix the brackets at the correct distance from the floor
and hang the unit on the hooks of the brackets. and mark the wall.
Use the polystyrene packaging to level the heater and protect the
floor.
Temperature
selector
Mode
selector
SUN mode
indicator
MOON mode
indicator
Heating
indicator
