4
ENGLISH
: SAFETY INSTRUCTIONS
The following are important notes on the installation, use and maintenance. Save this instruction manual for
future reference. Use the equipment only as specified in this guide. Any other use is considered improper and
dangerous. Therefore, the manufacturer cannot be held responsible in the event of damages caused by
improper, incorrect or unreasonable use.
Before use, ensure the equipment is undamaged. If in doubt, do not attempt to use it and contact the
authorized service center. Do not leave packing materials (i.e. plastic bags, polystyrene foam, nails, staples,
etc.) within the reach of children as they are potential sources of danger; always remember that they must be
separately collected. In case of failure and / or malfunction do not tamper with the unit. To repair the
appliance, always contact the service center authorized by the manufacturer and request the use of original
spare parts. Failure to comply with the above may compromise the unit safety and invalidate the warranty.
invalidate the warranty.
-
Do not handle or touch the appliance with wet hands or bare feet.
-
Do not expose the appliance to harmful weather conditions such as rain, moisture, frost, etc.. Store the unit
in a dry place.
-
Children should be supervised to ensure that they do not play with the appliance; do not allow incapable
persons to use the product without supervision.
-
Place it on flat and stable surface to ensure a correct operation. Keep at a distance of 2 meters from
microwave ovens in operation, which can cause malfunctions due to electromagnetic interference.
-
Keep the unit out of the reach of children and away from heat sources and steam.
-
Place the food inside a containers and not directly on the scale. Gently put the containers on the scale.
Failure to comply these instructions may invalidate the warranty in case of damages.
-
After finishing weight operation, empty the scale.
-
The buttons should be pushed gently and only with fingers.
-
If the display does not light up, it could be a battery problem: check that they are correctly installed and
they are not exhausted.
-
Not suitable for commercial use. Household use only
-
Do not immerse in water or other liquids and avoid splashing of water; clean it with a damp cloth only. Do
not subject the product to strong impacts, serious damage may result.
-
Do not use as a shelf for supporting objects.
G20071
1 Display
2 ON/OFF - TARE key
3 UNIT key
4 Weighting surface
5 Contenitore
INSERT BATTERIES
The compartment for battery is under the scale. The scale works with 1xCR2032 lithium battery.
-
Open the door by pulling the lock tab. Remove any battery by gently pulling on the metal tab on the edge
of your battery. Insert the battery with the plus sign (+) facing up.
-
To insert, push the battery into its slot until it stops. Close the cover.
CAUTION
-
Always use lithium batteries CR2032 type.
-
Be sure to insert the battery according to the correct polarity as otherwise they may leak and damage the
scale. Such damage is not covered by warranty. When you are going not to use the unit for long time, it is
advisable to remove the battery to prevent the run-out.
-
Do not heat, disassemble or throw in fire. Batteries are collected separately. Dispose of exhausted batteries
correctly, as required by national regulation.
OPERATING THE UNIT
Press TARE (2) if you want to show 0 on the display. This is necessary in case value on display is different
from 0 even if nothing is on the scale, or if you want to use the “Tare” function.
