G-WEIKE LC Series, Руководство по эксплуатации, Страница: 60 / 75

59
movement module, laser module and electric 1O module.
3.2.1 Sequence of power-on and power-off
There is an instruction of sequence of power-on and power-off stuck on the master power
switch.
Sequence of power-in:
Master power supply of the machin
e
Water chilling system-> Laser power supply->
Computer-> Other auxiliary parts
Power-off is in the reverse sequence as:
Other auxiliary parts
→
Computer
→
Laser power supply
→
Water chilling system
→
Master
power supply of the machine
3.2.2 Movement debugging
Movement debugging is mainly to check if movement status of each movement shaft is
normal. At ex-factor, movement debugging has been performed in case of no accident occurred
during transportation and installation, there will be no any problems with the machine. The
followings are instructions for motor shaft movement, resolution setting, strike and limit
configuration, test on straightness and perpendicularity.
3.2.2.1 Motor shaft movement
After normal power-on of the machine, the No.1 controller and No.11 controller will
automatically reset (if automatic reset is set on the No.3/4 controller, they will also reset after
power-on.). After completing of reset, the system will enter s standby state
In standby mode, it is to press the four directional keys (X+,X-, Y+,Y-) on the control
panel for manually controlling movement of the laser head. If the four directional keys are
normal
in movement, it means X-axis and Y-axis motor are normal in movement. Please refer to the
operation instructions of the related control system far movement testing. In case of failure found
with the motor shaft movement, please contact customer service personnel from our company for
a solution.
The following is an illustration of control panel of MPC 6525 controller:
Attention:Users should operate following the requirements as per power-in and
power-off sequence. Otherwise, failure may be caused to the machine.