13
10.2016 | G28706 | Designed in Germany
Press the
▲
arrow, STOP or
▼
arrow twice within 10 seconds (the
fi
rst time to switch
on the display of the handheld radio transmitter and the second time to send the radio
code).
The LED lights up for longer (1 second) to con
fi
rm that the handheld radio transmitter
has been saved correctly. The LED then goes out and remains in the inactive state.
If the handheld radio transmitter has not been saved correctly, the LED emits fast
fl
ashing signals for 1 second. The LED then goes out and remains in the inactive state.
Reasons for incorrect saving could be that the memory is full, for example, or that the
handheld radio transmitter is incompatible.
Deleting the stored handheld radio transmitter
To delete the stored handheld radio transmitter completely, proceed as follows:
Press the "PRG" button on the ELTRAL KS30/40 RADIO CONTROL chain drive (for
approx. 20 seconds) until the LED
fl
ashes quickly. Release the "PRG" button.
The LED continues
fl
ashing until all handheld radio transmitters that have been saved
are deleted.
Saving a handheld radio transmitter in remote mode
A new handheld radio transmitter can only be saved in remote mode, i.e. without pressing the
"PRG" button, if at least one handheld radio transmitter has been saved beforehand and this
handheld radio transmitter is to hand.
To save a handheld radio transmitter in the ELTRAL KS30/40 RADIO CONTROL chain drive,
proceed as follows:
Select the required channel at the handheld radio transmitter to be saved (in doing so
refer to the operating instructions of the handheld radio transmitter).
Press the F1, F2 and STOP buttons one after the other at the handheld radio transmitter
that has already been saved in the ELTRAL KS30/40 RADIO CONTROL. This key
combination is the same as pressing the "PRG" button at the ELTRAL KS30/40 RADIO
CONTROL.
Press the
▲
arrow, STOP or
▼
arrow twice within 10 seconds on the handheld radio
transmitter to be saved (the
fi
rst time to switch on the display of the handheld radio
transmitter and the second time to send the radio code).
The LED lights up for longer (1 second) to con
fi
rm that the handheld radio transmitter
has been saved correctly. The LED then goes out and remains in the inactive state.
If the handheld radio transmitter has not been saved correctly, the LED emits fast
fl
ashing signals for 1 second. The LED then goes out and remains in the inactive state.
Reasons for incorrect saving could be that the memory is full, for example, or that the
handheld radio transmitter is incompatible.
NOTE
When the ELTRAL KS30/40 RADIO CONTROL chain drive is
installed, the LED may not be visible.
Ventilation function
The handheld radio transmitter can be used to execute a function referred to as "ventilation".
When this key combination is pressed, the window is opened for 5 minutes.
To activate the ventilation function, proceed as follows:
Press the F1, F2 and arrow
▲
buttons one after the other.
The window opens. It closes once again after 5 minutes.
If the ELTRAL KS 30/40 RADIO CONTROL receives a further remote control command, the
ventilation function is aborted.
To resume ventilation, press the key combination described above once again.
