G-Tek LmNet - PRO 614-00, Руководство по эксплуатации

Страница: 42 / 53

G-Tek Corporation Private Limited 41
7.3.9.8 Alarm Set Point Low
In this parameter we must set the value to alert us whenever device reading goes low than the set
value, and that value should be set from -3276.8 to 3276.7
To set the Alarm Set point low for a channel then follow the procedure shown in figure- 45 by pressing
the appropriate buttons given in the front panel of the LmNet.
Above function Alarm set point high and Alarm set point low set the range, If the value increase and
decrease from high and low range respectively then internal buzzer provided will set also the relay
activate the Industrial buzzer make sound till value will not come back within range.
7.3.10 Channel 2
Same as Describe in Type of Functions 7.3.9 CHANNEL 1
7.3.11 Channel 3
Same as Describe in Type of Functions 7.3.9 CHANNEL 1
7.3.12 Channel 4
Same as Describe in Type of Functions 7.3.9 CHANNEL 1
7.3.13 IP Reset
We can reset IP address by pressing down key at power up for 5 seconds and then release it. At power
up, if we press down key for 5 seconds, IP address of device will be reset at default IP address as per
Table 3 . Then after we can set our IP Address by opening web page.
Figure 46 IP Reset
Figure 45 Alarm Set Point Low
Press up key and down
key to change the value
10
ALrm SPL
SAvE
1 281.55