EN
Electronic Ballast dimmable 600W
Legend
1. OFF-Standby button
2. Up / down button
3. LED overdriver
4. LED 600W mode
5. LED 400W mode
6. LED 250W mode
7. LED OFF-Standby ---ERROR---
8. Lamp cable
9. Power cable
Wiring
Connect the lamp cable to reflector or E40 lamp holder.
(Only for authorised persons)
Choose a bulb
Connect a desired bulb 250W, 400W or 600W MH (metal highlight) or
HPS (high pressure sodium) into the E40 lamp holder or reflector.
Connect the main cable to a house hold socket 230V/50Hz.
Now the ballast is initialising all LED are blinking for for about 5 seconds.
After this the 7. LED OFF-Standby ---ERROR--- is on, 4. LED 600W
mode is blinking. Choose now with the 2. Up / down button the wattage
of the bulb, confirm with 1. OFF-Standby button, the
7. LED OFF-Standby ---ERROR--- will constantly shine.
Warning:
in case you choose higher wattage as the bulb is you will
seriously damage the bulb.
10
Start the ballast
Once you have choose the correct wattage start the bulb pushing the
1. OFF-Standby button. This can least up to 15-20 seconds to start the
bulb the first time. The ballast stores the ignition information. Next time
the bulb start immediately.
I
n case the ballast can not start bulb in the first 15-20
seconds the ballast will try again after a 2minutes cool down time. During this
time the 7. LED OFF-Standby ---ERROR--- is blinking 2
times.
During this time
the 7. LED OFF-Standby ---ERROR--- is blinking 2times. During this operation
you can not dim or change the Watt.
