Page 5
ence is detected. Connect PIR(IN+) to APTC(SS), PIR(Out) to APTC(Start), PIR(IN-) to APTC(Com).
Wireless Start Button
- This optional button transmits a start command to the APTC’s internal receiver.
Wireless Track Reed Switch
- Connect the track mounted reed switch to this module to eliminate long wire runs
between the track reed switch and the APTC. This module can be powered from track connections or a 9V battery
(A 200mah 9V battery will last for approximately 30 days). It transmits a stop command to the APTC. Its LED
should turn ON when the track switch is activated by a magnet.
The green APTC LED will blink OFF whenever a start or stop command is received, whether it is hardwired or
wireless.
The red LED on the APTC wireless receiver will turn ON whenever a wireless signal is detected.
Linking Wireless Start Button and Wireless Track Switch to the
APTC
This will be done prior to shipping, but in the event these devices are
not working,
you should follow this procedure.
The wireless receiver inside the APTC has a button on it. Press the button once and wait for LED to turn ON.
Then either press the Remote Start Button, or activate the Track Mounted Switch with a magnet to complete the
link.
Wireless Track
Mounted Reed
Wireless
Start Button
Motion
Detector