Instruction Manual
67AX and 67AD CCP Ground Microphone System | 5
Assembling the 67 Series System
The 67AX /67AD is delivered fully assembled.
If you have dissambled it(e.g. for inspection or similar) you can assemble it as described below:
1.
Place the small O-ring in the ridge in the center hole.
2. Place the assembled microphone, grid-side down, in the center hole on top of the small O-ring.
Arrange the cable attached to the microphone in the cavity surrounding the mounted micro-
phone and fi t the cable in the ridge that leads to the outer edge of the plate.
3.
Place the large O-ring in the ridge near the edge of the cavity. The large O-ring must lie on top
of the cable.
4. Fit the cover plate on top of the microphone and O-ring assembly and fasten in place with 8
screws.
5. Fasten the safety clip over the cable with 2 screws.
These steps are shown in Fig. 1.
1
2
3
4
5
(× 8)
Fig. 1.
A view of the order for assembling the parts of the 67AX/67AD.
