© 2012 G Force Automatic Gates All Rights Reserved
DSG DC2 GATE MOTOR
INSTALLATION AND SET UP
INSTRUCTIONS
© 2012 G Force Automatic Gates All Rights Reserved
Setting Open / Close Limit Switch Cams
LEFT HAND inward
opening gate
Bottom CAM =
CLOSE
Position
Top CAM =
OPEN
RIGHT HAND inward
opening gate
Top CAM =
CLOSE
Position
Bottom CAM =
OPEN
Ensure the Internal Release is disengaged (
see page 5
).
Manually move the gates into the closed position. Using a 5mm allen key loosen the socket
head bolt and rotate the correct cam until it clicks the corresponding limit switch (see above).
Re-tighten the cams. Repeat for second motor.
Manually move the gates into the open position. Using a 5mm allen key loosen the socket head
bolt and rotate the correct cam until it clicks the corresponding limit switch (see above). Re-
tighten the cams. Repeat for second motor.
Engage the Internal Release (
see page 5
).
CAUTION
:
The gates will now open / close when
the gate motor is activated.
Press the handset remote and activate the gate motors to check the gate is stopping at the
required open position and closed position. Adjust the cam positions as necessary. Test the
gate motor several times to ensure the gate is stopping in the correct positions.
Ensure the gate motor is turning in the correct direction for opening the gate and the GREEN
LED light is on OR the correct direction for closing the gate and the RED LED is on as per the
pre-installation set up.
Socket Head
Bolt
Top
Cam
Limit Switches
Bottom
Cam
FOR OUTWARD OPENING GATES REFER TO THE SPECIAL INSTRUCTION SHEET
Care should be taken as there are moving components inside the gate
motor that may cause damage or personal injury.
