11
Maintenance
General maintenance
•
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from
various types of commercial solvents and may be damaged by their use. Use a clean cloth to
remove dirt, dust, oil, grease, etc.
WARNING: Do not at any time brake fluids, gasoline, petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can damage, weaken, or destroy plastic which may result
in serious personal injury.
•
After using the drill press, clean it completely and lubricate all sliding and moving parts. Apply a
light coat of automotive type paste wax to the table and column to help keep the surfaces clean.
Lubrication
•
Lower spindle to maximum depth and oil moderately once every three months.
•
Oil the column lightly every two months.
•
If cranking becomes difficult, grease gear rack lightly. The ball bearings in the tool are
permanently lubricated.
Motor/Electrical
The induction motor is easy to maintain but must be kept clean. Do not allow water, oil, or sawdust to
accumulate on or in it. The sealed bearings are permanently lubricated and need no further attention.
Head Assembly and Motor Housing
Frequently blow out any dust that may accumulate inside the head assembly and/or motor housing.
Pulleys
Should you feel an unusually high level of vibration, the pulleys may not be tightly secured on the motor
and/or spindle shafts. To make sure the pulleys are properly seated and tight, locate the set screw on
each of the pulleys. Tighten each set screw with the hex key.
Gear Rack
Periodically lubricate the worm gear and gear rack to keep the vertical movement smooth and to help
prolong the life of the drill press.
