Charging Mode
: This mode charges the selected battery type under normal conditions.
The charger will automatically change its charging cycle depending on the open-circuit
voltage of the battery. The charger will stop charging the battery automatically once the
battery is fully charged. It is very important that the correct battery type is selected to
protect both the battery and the charger.
Programming Mode
: This mode provides a stable voltage source for the vehicle’s
electrical system allowing the electronics to be diagnosed and programmed in a safe
environment. Before selecting the programming mode, please ensure that the vehicles
battery has been fully charged to prevent instabilities in current due to charging. The
charger’s output voltage can be changed from 12 to 14.8V manually, please select the
appropriate voltage according to the service manual of the vehicle. Please note that this
charger has a maximum output of 35A, make sure that the load does not exceed this
value or damage may occur to the electrical system of the vehicle.
Showroom Mode
: This mode provides power to a vehicle that is used for exhibition or
demonstration purposes to prevent deeply discharging or damaging the vehicles battery.
When this mode is selected, the vehicles battery will be maintained and kept fully charged.
Repair Mode (Hidden Mode)
: Once the charging mode is selected, this mode functions
automatically when the open-circuit voltage of battery is in a certain range. Batteries that
have not been used for long periods of time will be recovered by this mode.
Replacement mode:
This mode should be used when the battery of a vehicle needs to be
replaced and the supply of power to the vehicle cannot be interrupted. In this mode, the
charger will supply power to the vehicle in the place of the battery. When replacing the
battery, ensure that all ancillary features are turned off to reduce the load on the system
to a minimum.
Alarm
Poor connection alarm:
Indicates that the clamps and connections are not properly
secure. If this alarm still indicates poor connections once the connections have been
properly secured and the battery voltage is above 5V, remove the clamps and clean the
electrodes, and reconnect the clamps with the electrodes. If the alarm is still indicating
poor connections, please contact your distributor for further information.
High temperature alarm:
Indicates that the temperature is too high for safe operation. In
this case remove the connecting clamps. DO NOT turn off the charger. It needs the built-in
cooling fan to cool the charger faster. The alarm will be canceled once the temperature
has returned to normal. If the alarm is indicated when first connecting the charger or the
temperature is not high, please do not attempt to use the charger and contact your
distributor for further information.
