FXA FXACDS-8412S Скачать руководство пользователя

Страница: 9 / 56

The battery charge indicator on the plug shows the
charging process. During the process the indicator
shows a red light. When the battery charge indicator
shows a green light, the battery is fully charged.

During the procedure, the handle of the tool warms up.
This is normal.

The drill requires 1 hour to fully charge.

Disconnect the battery charger from the mains supply
when not in use.

Note:

The power tool cannot be used during the

charge procedure.

VARIABLE SPEED CONTROL (PIC. 3)

Simply apply light pressure to the trigger to start the
drill on a slow speed. Increasing the pressure will allow
a variable speed increase. Always remove the battery
before carrying out any adjustments or maintenance.

KEYLESS ChUCK OPERATION

The keyless chuck fitted to this drill/driver allows for
the easy installation and removal of bits and drills (Pic.
4).

The chuck has two rotating grips (A and B). Select the
drill/driver bit required and insert it into the chuck jaws,
turn grip A in a clockwise direction until jaws grip the
drill/driver bit. With your free hand hold grip B firmly
and rotate grip A in a clockwise direction until it
tightens onto the drill/driver bit. Do not use
unnecessary force to tighten.

Re-fit the battery, your drill/driver is now ready for use.

TORQUE ADJUSTMENTS

This feature allows setting of the torque or tightening
power of your drill/driver and depending on the
application, various levels of driving power are
required. When driving larger screw diameters a higher
torque power is required to drive the screw until it’s
properly seated.

When the selected torque is reached the chuck will
stop rotating (Pic. 5).

NOTE - Always start on the lowest setting.

The symbol

gives the highest torque setting and

is used when drilling and for driving larger screws.

FORWARD & REVERSE SWITCh (PIC. 6)

This feature is selected via a slide switch located
above the trigger. To select direction of the drill
rotation simply push the button fully in on the left side
for reverse rotation. To change to forward rotation,
push the button fully in on the right side of the handle.

WARNING!

The machine is designed as a drill and driver. Do not
attach any other accessories other than those
recommended.

NOTE

- As a safety precaution from accidental

engagement while being carried pushing the
forward/reverse button into the middle or neutral
position will render the drill inoperative.

TWO SPEED GEAR TRAIN

This drill comes with a 2 speed gear train to give high
and low speed ranges. To change between the two
speed ranges slide the selector switch, located on top
of the drill, Fig.7.

Use the low (L) speed for high power and torque
applications and high (H) speed for fast drilling or
driving applications.

Do not use the speed speed gear train while the tool is
running. The tool may be damaged.

LED WORK LIGhT

Caution: Do not look in the light or see the source of
light directly.

Pull the On/Off trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being
pulled. The lamp goes out immediately after releasing
the trigger.

hINTS FOR SCREW DRIVING

1) Use candle or bees wax on the screw threads to
speed application.

2) Whenever possible drill small diameter pilot holes for
faster screwing, eliminating the possibility of splitting
the wood.

TEChNICAL SPECIFICATION

Voltage

10.8V DC

No load speed

0-400/0-1350min

-1

Torque settings

21+1

Maximum torque