FXA 501976763, Инструкция по эксплуатации

Страница: 8 / 61

8
•
Wait until the auger impeller comes to a complete stop. Disconnect the spark plug wire to
prevent unintended starting.
• Check bolts and screws for proper tightness at frequent intervals to keep the machine in
safe working condition. Also, visually inspect machine for any damage.
•
Do not change the engine governor setting or over speed the engine. The governor
controls the maximum safe operating speed of the engine.
• Snow thrower shave plates and skid shoes are subject to wear and damage. For your safety
protection, frequently check all components and replace with original equipment
manufacturers (OEM) parts only. Use of parts which do not meet the original equipment
specifications may lead to improper performance and compromise safety.
•
Check control levels periodically to verify they engage and disengage properly and
adjust, if necessary. Refer to the adjustment section in this operator's manual for
instructions.
•
Maintain or replace safety and instruction labels, as necessary.
•
Observe proper disposal laws and regulations for gas, oil, etc. to protect the environment.
• Prior to storing, run machine a few minutes to clear snow from machine and prevent
freeze up of auger impeller.
•
Never store the machine or fuel container inside where there is an open flame, spark or
pilot light such as water heater, furnace, clothes dryer etc.
• Always refer to the operator's manual for proper instructions on off-season storage.
• Check fuel line, tank, cap and fittings frequently for cracks or leaks. Replace if necessary.
•
Do not crank engine with spark plug removed.
•
Have the machine inspected annually by an authorized service dealer to ensure that all
mechanical and safety systems are working properly and do not worn excessively. Failure
to do so can result in accidents, injuries or death.
DO NOT MODIFY THE ENGINE
To avoid serious injury or death, do not modify engine in any way. Tampering with the governor
setting can lead to a runaway engine and cause it to operate at unsafe speeds. Never tamper
with factory setting of engine governor.