FXA 501739306, Инструкция по эксплуатации

Страница: 8 / 42

8
Check the power cable. Never use a faulty or
damaged power cable.
Do not use the cable to pull the plug out of the socket.
Protect the cable from heat, oil and sharp edges.
Do not leave the saw in the rain and never use it in
damp or wet conditions.
Provide good lighting.
Do not saw near flammable liquids or gases.
Wear suitable work clothes! Loose garments or
jewellery may become caught up in the rotating saw
blade.
Non-slip shoes are recommended when working
outdoors.
Wear a hair net if you have long hair.
Avoid abnormal working postures.
Operators must be at least 16 years of age.
Keep children away from the machine when it is
connected to the power supply.
Keep your workplace clean of wood scrap and any
unnecessary objects.
An untidy work area invites accidents.
Do not allow other persons, especially children, to
touch the tool or cable. Keep them out of your work
area.
Persons working on the machine should not be
distracted.
Note the direction of rotation of the motor and saw
blade. Use only blades whose permissible maximum
speed is not lower than the maximum spindle speed
of the circular saw and of the material to be cut.
After you have switched off the motor, never slow
down the saw blade by applying pressure to its side.
Only fit blades which are well sharpened and have no
cracks or deformations.
Do not use circular saw blades made of high-alloy
high-speed steel (HSS).
Do not use circular saw blades made of high-alloy
high-speed steel (HSS).
Only use saw blades that are recommended by the
manufacturer, comply with EN 847-1 and bear a
warning note. When replacing the saw blade ensure
that the cutting width is no smaller and the basic
blade thickness of the saw blade is no larger than the
thickness of the splitter.
Faulty saw blades must be replaced immediately.
Never use saw blades which do not comply with the
data specified in this manual.
Never dismantle the machine’s safety devices or
render them inoperative.
If the table insert is worn, replace it.
Always stand to the side of the saw blade when
working with the saw.
Never load the machine so much that it cuts out.
Make sure that off-cuts do not catch on the saw blade
crown. Risk of catapulting!
Never remove loose splinters, chips or jammed pieces
of wood when the saw blade is running.
To rectify faults or remove jammed pieces of wood,
always switch off the machine first. Pull the power
plug!
If the sawing gap is worn, replace the table insert. Pull
the power plug!
Carry out retooling work, adjustments, measurements
and cleaning jobs only when the motor is switched off.
Pull the power plug!
Before switching on, make sure that all keys and
wrenches have been removed from the tool.
Switch off the motor and pull the power plug before
you leave the workplace.
Refit all guards and safety devices immediately after
you have completed any repairs or maintenance work.
Be sure to observe the safety information and
operating and maintenance instructions issued by the
manufacturer, as well as the dimensions listed in the
Technical Data.
It is imperative to observe the accident prevention
regulations in force in your area as well as all other
generally recognized rules of safety.
Note the information published by your professional
associations (VBG7j).
Do not use any low-powered machines for heavy duty
work.
Do not use the cable for purposes for which it is not
designed.
Make sure you stand squarely and keep your balance
at all times.
Check the tool for damage.
Each time before re-using the tool, carefully check
that the guards or any slightly damaged parts are
working as intended.
Check that the moving parts are in good working
order, that they do not jam, and that no parts are
damaged. Make sure that all parts are fitted correctly
and that all other operating conditions are properly
fulfilled.