FWE MOISTURE-TEMP CABINETS
COMPLETE AND RETURN YOUR WARRANTY CARD
2
...and thank you for purchasing an
FWE MOISTURE-TEMP
cabinet.
Your unit has been designed and manufactured under
rigid controls to assure you the most efficient service.
Please take a moment to read through this booklet of important
information pertaining to your cabinet. By following a routine
of proper use and care described on the following pages, your
cabinet will last for many years.
IMPORTANT:
Your Manufacturer Registration Card must be
returned within 30 days after initial delivery to put warranty
into effect.
CONGRATULATIONS
ELECTRICAL REQUIREMENTS AND GROUNDING
UNPACKING
The amperage of your cabinet is stamped on the name plate
serial tag attached to the unit. FWE models are equipped with
a three prong grounding cord plug for your protection against
possible shock hazards. Be sure to plug only into a properly
grounded three prong wall receptacle. If you have any questions
with regard to adequate wiring or grounding in your building, a
qualified electrician should be contacted before using your cabinet.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.
WARNING: ONLY A QUALIFIED ELECTRICIAN SHOULD ATTEMPT
TO REPAIR OR REPLACE ELECTRICAL COMPONENTS OR WIRING.
BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.
After uncrating your cabinet, remove all tape and padding which
held all doors, shelves, racks, cord, etc., in place during shipment.
These numbers are found on the nameplate (serial tag) affixed
near the rear of the unit. Please record them in this booklet,
in the space provided When ordering parts and/or service, you
will need to provide this information. The voltage and amperage
of the unit are also stamped on the serial tag.
SERIAL AND MODEL NUMBER
