TROUBLE-SHOOTING
8
FWE MOBILE SERVING STATION
TROUBLE-SHOOTING CHART
Check this list first before you call for service.
* *
NOTE: CALIBRATION IS EXCLUDED FROM FWE WARRANTY.
Thermostats on all units are
calibrated at the factory prior to shipping. Due to conditions in transit, beyond our control, occasionally units
will need to be re-calibrated prior to use. This is a simple procedure for which instructions are given above.
(1B, 2E)
*
Heating element will either function or not function. Only a slight warmth indicates a problem
with the thermostat, not the element.
PROBLEM POSSIBLE CAUSE REMEDY
TEMP
TOO
HOT
TEMP
NOT
HOT
ENOUGH
NO
HEAT
AT ALL
1A] Adjustable thermostat set too high
1B] Thermostat needs re-calibrating*
2A] Opening door unnecessarily
2B] Thermostat set too low
2C] Cord plug pulled out from outlet
2D] Fuse blown - no power to outlet
2E] Thermostat out of calibration**
3A] Cabinet not plugged into outlet
3B] Thermostat knob at “ OFF ”
3C] Rocker switch at “ OFF ” position
3D] Fuse Blown - no power to outlet
3E] Thermostat needs replacing
3F] Heating element burned out*
1A] Set thermostat at a lower temperature
(no lower than 140°F).
1B] Loosen screw in thermostat knob and remove knob.
Adjust set screw in hollow stem with small blade screwdriver
by turning CLOCK-WISE. 1/4 turn lowers temperature
approximately 10°F. DO NOT REMOVE SET SCREW.
2A] Keep door closed and latched shut as much as possible.
2B] Set thermostat at a higher temperature.
2C] Replug cord into proper outlet.
2D] Have a qualified electrician check power and fuse box.
2E] Loosen set screw in thermostat knob and remove knob.
Adjust set screw in hollow stem with small blade screwdriver
by turning COUNTER-CLOCKWISE. 1/4 turn raises tempera-
ture approximately 10°F. DO NOT REMOVE SET SCREW.
3A] Plug cabinet into properly grounded electrical outlet.
3B] Adjust thermostat knob to temperature
setting required.
3C] Turn switch to “ ON ” position.
3D] Have a qualified electrician check power to fuse box.
3E] Unplug cabinet from electrical source. Loosen set screw
in thermostat knob and remove knob. Remove control panel,
disconnect wires from terminals on thermostat, and remove
2 screws holding thermostat to control panel. Replace
thermostat with new one, and re-install control panel and
thermostat knob.
3F] Unplug cart from electrical source. Remove screws
holding heating element in place. Gently pull element away
from back wall a few inches to expose wire connections. Dis-
connect wires, and replace element with new one. Reconnect
wires, secure element with screws.