FWE Removable Heat Module or models operate on 120 volt,
60 Hz, 1 ph, A.C. (unless ordered otherwise), and are equipped
with a three prong grounding cord plug for your protection against
possible shock hazards. Be sure to plug only into a properly
grounded three prong wall receptacle. If you have any questions
with regard to adequate wiring or grounding in your building, a
qualified electrician should be contacted before using your
cabinet. The amperage of your heat module is stamped on the
name plate attached to the unit.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.
WARNING:
ONLY A QUALIFIED ELECTRICIAN SHOULD
ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.
BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.
FWE ETC CABINET WITH REMOVABLE HEAT MODULE
SERIAL AND MODEL NUMBER
INSTALLATION AND CARE
UNPACKING
ELECTRICAL REQUIREMENTS AND GROUNDING
These numbers are found on the nameplate (serial tag) affixed
to the back of the unit. Please record them in this booklet, in the
space provided. When ordering parts and/or service, you will
need to provide this information. The voltage and amperage of
the unit are also stamped on the serial tag.
After uncrating your cabinet and heating unit, remove all tape
and padding which held all doors, shelves, racks, cord, etc., in
place during shipment.
4
