FLATLINE VAN CO • [email protected] • 888-667-5576
LET’S GET STARTED!
1.
SLIDE HALF OF THE RAIL NUTS INTO THE PASSENGER SIDE FACTORY ROOF
RAIL, AND HALF OF THEM INTO THE DRIVER SIDE RAIL.
NOTE-
IF YOU’RE INSTALLING A SIDE LADDER, GRAB THE TWO RAIL
NUTS FROM YOUR LADDER HARDWARE PACK, AND PUT THOSE TWO
IN ON THE DRIVER SIDE. THESE CAN BE ADDED LATER, IT JUST
SAVES TIME TO DO IT NOW.
2.
NEXT, BEGIN ASSEMBLING YOUR SIDE RAILS. GRAB YOUR 8
SIDE RAIL
WELDMENTS
, 10
BAYONETS
, AND 10
RAIL MOUNTS
. BEGIN ASSEMBLING THEM
AS SHOWN IN
FIGURE 1
. WE FIND THAT A GOOD SIZED TABLE OR
WORKBENCH MAKES THIS A BIT EASIER. TO ASSIST ALIGNMENT, IT’S
SUGGESTED TO USE SOME QUICK CLAMPS AS SHOWN IN
DETAIL D
(SEE
NEXT PAGE FOR DETAIL). TIGHTEN THE
SIDE RAIL WELDMENTS
AND
BAYONETS
, BUT LEAVE THE
RAIL MOUNTS
SLIGHTLY LOOSE TO ALLOW
ADJUSTMENT.
NOTE-
THE CARRIAGE BOLTS THAT ATTACH THE RAIL MOUNTS CAN
BE MOUNTED FACING UPWARD OR DOWNWARD FOR A CLEAN LOOK.
5
FIGURE 1
