21
10–15 cm from the base of the branch saw upwards into the branch 1/3 of the branch
diameter (1).
A little further up the branch saw through the branch from top to bottom (2).
Make a cut close to the trunk (3). Make the cut from top to bottom.
When limbing trunks lying flat on the ground, first always saw off the branches pointing
upwards. Do not cut through supporting branches until the trunk has been sawn into lengths.
Risk of injury!
Branches which are supported or under tension may wedge the saw chain in the wood!
Maintenance and care
WARNING!
Before performing any work on the garden tool, remove the battery.
Risk of injury by the sharp cutters! Wear protective gloves.
In the interest of your own safety!
Perform only the maintenance work described here yourself. All other work, in particular
motor maintenance and repairs, must be performed by a trained specialist. Improper work
may damage the power tool and also result in injuries. Have power tool inspected once a
year at a service centre.
Overview of cleaning and maintenance
After using the power tool
Clean the unit.
Regularly, depending on the application conditions
Tension the saw chain. Clean oil guide groove in the saw rail.
Regrind saw chain. Check saw chain oil level, top up if required.