Operators and Technicians Manual
©
2006 – 2007 FutureLogic, Incorporated. All Rights Reserved.
MNL Page 11 of 29 12/06/2007
MNL-000030 REV.X07
4
Ports
Introduction
This chapter describes the interface connectors and port pin-outs for the printer. For complete
electrical specifications on these ports, refer to Appendix A in the Developers Manual
(MNL-000029) for the power connector.
Note:
While PSA-66-ST2 refers to all models of the printer, the content of this manual is
primarily for the Netplex/USB interface of the GEN2 Universal printer (PSA-66-ST2NU). For
additional information on the Netplex and USB interfaces, please contact IGT.
Front Bezel Port
Figure 4-1
Front Bezel LED Control Port
Table 4-1 lists information on the LED bezel port on the printer. This is an open drain
modulated high side drive 25VDC port capable of driving up to a maximum 1.5A.
Table 4-1
Front Bezel LED Control Port Pins
Pin
Function
1
Switched 25VDC, 100mA Min
2 BGND
3
Frame (Chassis) Ground
Connector: Molex Micro-Fit 43640-0301
Mate:
Molex Micro-Fit 43645-0300
Bezel LED Control Port
1
2
3
