• Turn the encoder to select
“ON”
if you wish to strike the lamp or
“OFF”
in order to switch it off.
• Press the encoder to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
Lamp on/off by power on
With this function you can select if the the lamp will be switched on when switching the power on. Select
“ON”
by turning the encoder if you wish to enable this function or
“OFF”
if you don’t.
Lamp on via external controller
With this function you can select if you can switch the lamp on via an external controller (DMX-channel 22,
value 64-79). Select
“ON”
by turning the encoder if you wish to enable this function or
“OFF”
if you don’t.
Lamp off via external controller
With this function you can select if you can switch the lamp off via an external controller (DMX-channel 22,
value 224-239). Select
“ON”
by turning the encoder if you wish to enable this function or
“OFF”
if you don’t.
Lamp Off if no DMX
With this function you can select to switch off the lamp off automatically if there is no DMX signal). Select
“ON”
by turning the encoder if you wish to enable this function or
“OFF”
if you don’t.
Lamp on at temp.
With this function you can set the inside temperature from which the projector will restrike the lamp after
automatic lamp shutoff.
Lamp off at temp.
With this function you can set the inside temperature at which the projector will automatically switch the lamp
off. Turn the encoder to select the maximum inside temperature betwwen 60° C an d159° C. Inside
temperatures below 90° C are not critical. 90° C and more should lead to the lamp being switched off. Please
note that the outside temperature should not exceed 45° C.
Display set
Display close time
With this function you can shut off the LED display after 2 to 59 minutes. Turn the encoder in order to select
the desired shut off time.
Display intensity
With this function, you can adjust the display-intensity from 20 % to 99 %. Turn the encoder in order to select
the desired intensity.
Init effect
With this function, you can adjust with which value the respective channels will start.
Mic sensitivity
With this function, you can select the desired microphone sensitivity between 20 % and 99 %.
Reset-functions
With this function you can Reset the device via the Control Board. You can select the different Reset-
functions by turning the encoder.
Restore factory settings
With this function you can restore the factory settings of the device. All settings will be set back to the default
values (shaded). Any edited scenes will be lost.
Effect Adjust
Test function of each channel
With this function you can test each channel on its (correct) function.
Lamp adjustment
With this function, you can adjust the lamp more easily. All effects will be canceled, the shutter opens and
the dimmer intensity will be set to 100 %. With the individual functions, you can focus the light on a flat
surface (wall) and perform the fine lamp adjustment.
51838375_V_1_2.DOC
53/110
