51837558_V_1_2.DOC
25/53
Caution:
At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
Ω
resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
Addressing
Each projector occupies 5 channels. To ensure that the control signals are properly directed to each
projector, the projector requires adressing. This is to be done for every single projector by changing the DIP
switches as set out in this table.
The starting address is defined as the first channel from which the EVO-5 will respond to the controller.
Please make sure that you don’t have any overlapping channels in order to control each EVO-5 correctly and
independently from any other fixture on the DMX data link. If two, three or more EVO-5 are addressed
similarly, they will work similarly.
Occupation of the DIP-switches:
Device 1 - channels 1-5
DMX-starting
address
Projector number
& channels
Device 2 - channels 6-10
Device 3 - channels 11-15
Device 4 - channels 16-20
Device 5 - channels 21-25
1
2
4
8
16
32
64 128 256
DIP-switch no.
1
2
3
4
5
6
7
8
9
Setting the DMX-
starting address:
On
Off
Off
On
Off
On
Off
On
Off
On
Off
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
Lighting effects must not be connected to dimming-packs.
OPERATION
After you connected the effect to the mains, the EVO-5 starts running. During the Reset, the motors are
trimmed and the device is ready for use within approximately 20 seconds.
Turn the objective-lens for adjusting the focus in order to obtain a sharp projection.
Stand Alone operation
In the Stand Alone mode, the EVO-5 can be used without controller. You can do without a controller as the
EVO-5 features a built-in microphone, which provides automatic sound control.
Disconnect the EVO-5 from the controller and set the DIP-switch 10 to On.
The lamp is automatically ignited as soon as the condensor microphone receives music signals.